This video shows you the steps to configure Root Bridge using the Root Primary and Root Secondary commands on Switches using Cisco Packet Tracer. ✅ S U B S C R I B E ► goo.gl/8d0iG9 ✅ Article ► www.sysnettechsolutions.com/en/root-primary-command/ To configure Root Bridge: Step 1: Firstly, add 4 Switches and 2 computers to the PT workspace. Step 2: Connect the Cisco Switches with Cross cable and wire all devices to ensure redundancy. Step 3: Configure the TCP/IP settings on the two computers you added. Step 4: Next, specify the #Switch you will configure #Root #Bridge. Step 5: Open the CLI command prompts of the switches and execute the show spanning-tree command in enable mode and check and note the Priority values. Step 6: At the CLI command prompt of the device you will configure as root, execute the command spanning-tree vlan 1 root primary in config mode. Next, verify the value (This bridge is the host) in the Root ID section with the show spanning-tree command in enable mode. Step 7: Now execute the spanning-tree vlan 1 root secondary command in config mode on the relevant device to configure the Secondary device on the network. Then, run the show command in enable mode again and check the Priority value in the Root and Bridge ID section. The value here will be lower than the Priority values ​​of other devices on the network. Step 8: Now, to verify the redundancy on the network, completely power down the Root Bridge device or shut down some of its ports with the shutdown command. In the meantime, execute the show command on the Secondary device and verify that it is Root. Step 9: Do not forget to subscribe to our YouTube channel for more videos about Packet Tracer training! ───────────────BEST PRODUCT──────────────── ✅ Buy ► bit.ly/CiscoPacketTracerSimulator ───────────────RELATED VIDEOS─────────────── ➊ How to Configure DHCP Relay Agent ➦ www.youtube.com/watch?v=kIBviWl-378 ➋ How to Use Rommon Mode on the Cisco Router ➦ www.youtube.com/watch?v=_d9NZEDi0O8 ➌ How to Copy the Cisco Router IOS to TFTP Server ➦ www.youtube.com/watch?v=Ik-ILkmNd2s ➍ How to Configure RIP Version 2 ➦ www.youtube.com/watch?v=RwiKhrLkHgw ➎ How to Configure RIP Routing ➦ www.youtube.com/watch?v=x3Oz4Y4j9GM ───────────────FOLLOW US─────────────────── ✔ Facebook ➦ www.facebook.com/SysnettechSolutions/ ✔ Twitter ➦ twitter.com/SysnettechS/ ✔ Pinterest ➦ www.pinterest.com/SysnettechS/ ✔ Instagram ➦ www.instagram.com/sysnettech_solutions/ ✔ LinkedIn ➦ linkedin.com/in/tolqabaqci/ ███████████████████████████████████████████

Be the first to comment